1995 Chevrolet Cavalier Bleeding cooling system

1995 CHEVROLET CAVALIER
160,000 MILES • 2.2L • 4 CYL • 2WD • AUTOMATIC
Avatar
RTHOMAS44
  • MEMBER
  • 4 POSTS
I recently changed radiator,water pump and thermostat and tried bleeding the system but I get water coming out and then it goes back to running hot
Jun 9, 2014 at 5:01 PM
Advertisement
Avatar
SATURNTECH9
  • ASE Certified Mechanic
  • 30,869 POSTS
  • ASE Certified Mechanic
Have you had the radiator cap tested yet?Also is the radiator cooling fan turning on at the correct temp?
Jun 9, 2014 at 5:07 PM
Avatar
RTHOMAS44
  • MEMBER
  • 4 POSTS
I haven't when I start car up all fluids come out through cap also when bleeding, I get water gushing up but it still is holding a lot of air/pressure
Jun 9, 2014 at 5:39 PM
Avatar
SATURNTECH9
  • ASE Certified Mechanic
  • 30,869 POSTS
  • ASE Certified Mechanic
Have you checked to see if there is excessive pressure in the cooling system from maybe a bad head gasket.
Jun 9, 2014 at 6:37 PM
Avatar
RTHOMAS44
  • MEMBER
  • 4 POSTS
That is my next plan of action change gaskets and cap
Jun 9, 2014 at 6:45 PM
Avatar
SATURNTECH9
  • ASE Certified Mechanic
  • 30,869 POSTS
  • ASE Certified Mechanic
Before you change the head gasket I would make sure its bad.You can rent a chemical head gasket tester at auto zone for free y o u just have to by the chemical for it.
Jun 9, 2014 at 6:50 PM
Avatar
RTHOMAS44
  • MEMBER
  • 4 POSTS
I recently noticed the coolant isn't circulating properly out top radiator hose into engine. Also fan isn't coming on when. When vehicle runs hot
Jun 17, 2014 at 1:47 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.