1995 Camaro problem

50,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
Hi, I changed my IDLE following some high RPM probleme but know the car start and can run when cold but if I try to restart when it's hot it will only stay on if i play on acceleration and impossible to stabised the RPM and die.
Aug 15, 2011 at 8:57 PM
Advertisement
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
What was done to"changed my idle"?
Aug 16, 2011 at 5:54 AM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
idle air control valve
Aug 16, 2011 at 1:28 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
O.K. suspect EGR remove clean pintel and passagewats check to see if pintel stuck
Aug 16, 2011 at 1:35 PM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
Before to try I would like a confirmation on the piece I need to clean, If you wish check the photo it would help. As you can see it's in bad shape
Aug 16, 2011 at 3:16 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
That's the puppy
Aug 17, 2011 at 6:19 AM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
The EGR is perfectly intact of carbon,so look like the passagewats. I thinking when I removed the air control valve it was full of carbon; could it be the carbon of air control valve who block a passage or not?
Aug 17, 2011 at 8:28 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
Yes any carbon not good is check engine light comming on?
Aug 18, 2011 at 6:45 AM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
yes the check engine is on most off the time and off sometimes.
Aug 18, 2011 at 1:30 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
When light is on and have time go to AutoZone and have code read then post
Aug 18, 2011 at 2:06 PM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
ok, gonna try to find the code this afternoon, there is maybe one computer who could read it on my island...( the beauty of living on small pacific island)
Aug 18, 2011 at 3:26 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
Not on Guam are you?
Aug 19, 2011 at 2:05 PM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
No, I'm on Vanuatu (South West Pacific) and there is no other camaro in the country. For the code the first attempt failed (no adaptor). hope my friend gonna find the adaptor this week.
Aug 21, 2011 at 1:53 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
Could remove EGR and make a plate and block it off
Aug 22, 2011 at 8:30 AM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
EGR removed,pb still but coming better. Do the PCM need time to adjust
Aug 24, 2011 at 1:38 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
Possible get fuel pressure checked?
Aug 24, 2011 at 1:45 PM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
I made check the fuel pump on friday, they told me it was ok. This week-end I change the fuel filter, and check what could be bad on the fuel line. Fisrt thing I found was a lost wire on a sensor on the right of admission pipe (reconnected), I found also a pipe from the fuel line disconnected ( reconnected, well done for the garage who test the pump and didn't see it) I found a bucket behind the left rear whell with line to go to the fuel tank but not connected ( not reconnected yet). After this the car start good with normal rpm when cold, run good without check engine. On hot restart the engine go to 3000 rpm without check engine light off. I joint the photo of the differents elements for your understanding because I don't know the english name.
Aug 28, 2011 at 3:28 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
In last PIC the hose going to black right angle thing is PCV remove shake it should rattle, spring and plunger. The can thing is part of EVAP and hose needs to be hooked up. Other sensor looks like MAP that could effect idle. Is there a Vacuum hose to it?
Aug 29, 2011 at 6:04 AM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
ok for PVC pipe and Evap, The sensor is MAP and there is a hose connect to it.
Aug 29, 2011 at 1:54 PM
Avatar
DOCFIXIT
  • ✓Experienced Mechanic
  • 18,828 POSTS
Is there vacuum on MAP hose? if yes disconnect what happens?
Aug 30, 2011 at 7:36 AM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
When high RPM hose disconnetion make RPM back to 1000 but with strong fuel smell.
Aug 30, 2011 at 1:37 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Replied on August 19, 2011

Not on Guam are you?

Answered by Docfixit (expert)
11,844 answers provided

Doc let me deal with this-thanks!

I'm from this Island and one of the expert here and physically in the island -you got a number to call or address-Let me know
Aug 30, 2011 at 2:08 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
No, I'm on Vanuatu (South West Pacific) Doc I missed Q-

Did you replaced the IACV or just cleaned out-Let us know
Aug 30, 2011 at 2:15 PM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
sorry what is IACV?
Aug 30, 2011 at 5:15 PM
Avatar
XAVANUATU
  • MEMBER
  • 15 POSTS
If the docs need some graphic design let me know.
Aug 30, 2011 at 5:16 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement