1995 Skylark

1995 BUICK SKYLARK
6 CYL • 2WD • AUTOMATIC
Avatar
GONZO347
  • MEMBER
  • 1 POST
I was told to bleed the coolant thru the fitting on top of the water pump, how do I do this?
Dec 1, 2010 at 11:09 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
start the car up and there should be a fitting that has a smaller bolt and a larger one. put the car on a ramp to get that area higher than the rest of thecar. then open the top screw and there should be a litttle hole where coolant will come out.bleed it a little then if air comes out you';ll see it. its on the pipe going to the heater (black pipe) on top of engine.
Dec 1, 2010 at 11:17 PM
Advertisement