1994 Toyota Pickup Cause Failer Start After Following Imobiliser Procedure

1994 TOYOTA PICKUP
211,137 MILES
Avatar
NKRADEBE
  • MEMBER
  • 1 POST
what cause the failer to start after following all the imobiliser procedure. when the battery and starter is okay
Dec 24, 2012 at 1:11 PM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
from what i understand you r truck won't start.does it turn over? scan for codes and check fuel pressure to see if that is ok.
FUEL PUMP PERFORMANCE
Application (1) Pressure  psi (kg/cm2 )
Pickup 38 44 (2.7 3.1)
(1) Check fuel pressure with jumper wire installed between data link connector terminals +B and FP, ignition on and engine off.

Dec 24, 2012 at 2:36 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.