Advertisement

Ignition

170,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
4RUNNER135
  • MEMBER
  • 6 POSTS
I can not get any spark to the spark plugs.
I have checked primary and secondary resistance of the coil - in spec, checked resistance of high tension cord from coil to distributor - in spec, checked resitance of signal generator on distributor - in spec. Replaced Ignitor unit. Checked wiring bundles - they all look to be still sealed and where there are joints I've inspected and the wires look OK. I have power going to the coil and ignitor with the ignition switch turned to ON. The engine turns over but will not fire.
I have good compression and fuel to the cylinders, but can not figure out anything for spark.
Apr 10, 2011 at 1:36 PM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
You have done your homework-check wiring back to the computer-If the computer don't see an Ne input signal it'll not tell the ignitor to fire the coil and they'll be no IGF telling it that spark has occured
Apr 10, 2011 at 1:43 PM
Advertisement
Avatar
4RUNNER135
  • MEMBER
  • 6 POSTS
So this would be from the Ne terminal at the distributor?
Apr 11, 2011 at 6:21 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle