I have checked primary and secondary resistance of the coil - in spec, checked resistance of high tension cord from coil to distributor - in spec, checked resitance of signal generator on distributor - in spec. Replaced Ignitor unit. Checked wiring bundles - they all look to be still sealed and where there are joints I've inspected and the wires look OK. I have power going to the coil and ignitor with the ignition switch turned to ON. The engine turns over but will not fire.
I have good compression and fuel to the cylinders, but can not figure out anything for spark.
SPONSORED LINKS
Sunday, April 10th, 2011 AT 8:36 PM