MY odometer, speedometer, gas gage and other components on dash board quit working, what is wrong
Saturday, July 9th, 2011 AT 4:52 PM
5 Replies
SATURNTECH9
MECHANIC
30,869 POSTS
Have you checked all your fuses?Is the cluster plugged in or have a loose connection?If you smack the dash above your cluster will it start working?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, July 9th, 2011 AT 5:16 PM
TRHINO11
MEMBER
3 POSTS
Fuses are good, smacked the dash there is no change. How do you find out if the cluster is plugged in or loose? AND HOW DO YOU GET TO IT.
Was this
answer
helpful?
Yes
No
Saturday, July 9th, 2011 AT 6:34 PM
SATURNTECH9
MECHANIC
30,869 POSTS
If you look at the dash top up towards the wind shield in each corner there is a screw cover both of them off then unscrew the two 7mm screws. Then the edge of the dash top facing you there are retainng clips all along the edge of the dash top. Find each clip and pop them up at the clip with a large flat blade screwdriver. Then you can remove the dash top and gain access to the back of the cluster. So no warning lights dash lights or gauges work at all?
Was this
answer
helpful?
Yes
No
-1
Saturday, July 9th, 2011 AT 8:33 PM
TRHINO11
MEMBER
3 POSTS
That is correct nothing works at all the turn signals do but nothing else
Was this
answer
helpful?
Yes
No
Saturday, July 9th, 2011 AT 10:13 PM
SATURNTECH9
MECHANIC
30,869 POSTS
Ign 1 ten amp fuse in the inside fuse box feeds power to the cluster make sure with the key in the run position that there is power to both sides of that fuse. Let me know what you find.