1994 SAAB 900 stalling

1994 SAAB 900
150,000 MILES • 2.6L • V6 • FWD • AUTOMATIC
Avatar
GARY4181
  • MEMBER
  • 4 POSTS
you can be going down the road or highway and car just stalls and wont restart did it once at 70 mph and just did tit at 35mph. my mechanic thought it was a bad fuse connection because it started after messing with it.
but then two days later it did it again.
Apr 28, 2014 at 4:37 AM
Advertisement
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
Did he tell you which fuse he looked at, it well may be a bad connection in the back of the fuse holder.
Apr 28, 2014 at 4:44 AM
Avatar
GARY4181
  • MEMBER
  • 4 POSTS
injection system something
Apr 28, 2014 at 4:46 AM
Advertisement
Avatar
MHPAUTOS
  • CERTIFIED EXPERT
  • 31,937 POSTS
best get back to the mechanic and get him to have a close look at the circuit he was looking at, I feel that the problem is there.
Apr 28, 2014 at 4:49 AM
Avatar
GARY4181
  • MEMBER
  • 4 POSTS
helloooooo
Apr 28, 2014 at 5:07 AM
Avatar
THIS IS MIKE
  • CERTIFIED EXPERT
  • 686 POSTS
Intermittent stalling can be one of the hardest problems to diagnose. With 150k miles on your car the electrical system has been running for over 5000 hours and is prone to some failure. When your car is in the failed condition you have to test for spark and fuel pressure. If your mechanic has narrowed the problem to your injection circuit. I would test for fuel pressure first using a mechanical gauge connected to the fuel rail. Get a reading of what it is when the engine runs fine and test it again when it fails. It could also be your crank angle sensor, they can fail after they get warm and work again once it cools off.
Apr 28, 2014 at 9:20 AM
Avatar
GARY4181
  • MEMBER
  • 4 POSTS
where is this sensor located on the engine
Apr 28, 2014 at 10:36 AM
Avatar
THIS IS MIKE
  • CERTIFIED EXPERT
  • 686 POSTS
The crankshaft sensor is located behind the crankshaft pulley on the forward side of the crankcase toward the left. With the sensor unplugged measure the resistance between the sensor terminals, the resistance should be between 485-595 ohms or it should be replaced. It may test fine and still fail once it warms up.

Apr 28, 2014 at 2:38 PM