changed oil pan and now car wont start, changed starter and it just clicks everytime i try to turn it over what do i do now?
Dec 5, 2010 at 2:25 PM
1994 oldsmobile cutlass supreme 3.1 v6
1994 OLDSMOBILE CUTLASS
BLESSDX4
- MEMBER
- 1 POST
Advertisement
MMPRINCE4000
- ✓ASE Certified Mechanic
- 8,548 POSTS
Did you raise engine to get to pan? Did you remove starter to change pan?
Dec 5, 2010 at 2:30 PM
JDL
- ✓ASE Certified Mechanic
- 16,098 POSTS
Does the battery have a full charge? All cables, voltage and ground are good? Another issue could be your security system? The purple wire at the starter solenoid should be hot with the key in the crank position. Make sure the tranny is in park or neutral and the e-brake set before testing.
Dec 5, 2010 at 2:35 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.