My 4 rear speakers arent working in my Pathfinder.

1994 NISSAN PATHFINDER
178,000 MILES
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
My 1994 Nissan Pathfinder SE V6 I have the 4 Rear Speakers aren't working I looked at Fuses under the Dash and everything seems ok. The Front 4 are fine. I've pulled out the Deck and the Wires look fine but Im not sure about the Two compartments in the Trunk 1 on each side would either of those be for the stereo? I've pulled the Hoodiner in the Trunk off and the Speakers are connected so I'm wondering were I should look I'd appreciate your help thanks in Advance!
Sep 9, 2011 at 3:45 AM
Advertisement
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
Most of the time this is caused by loose wiring or a bad connection. You might want to remove all of the wires from the speakers one at a time and clean them and make sure they are tight. You could also turn the radio on and wiggle the wires to see if they start to work
Sep 9, 2011 at 10:35 AM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
I've tried I guess ill give it another shot thanks for your time.
Sep 9, 2011 at 3:55 PM
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
What happens when you wiggle the wires when the radio is on?
Sep 9, 2011 at 4:54 PM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
Nothing happens at all the front ones just stay on and work fine that's why I was wondering if there're might be a fuse in one of those compartments in the rear trunk or some kind of wiring for the speaker's.
Sep 9, 2011 at 5:13 PM
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
Is this a factory stereo? Have you tried turning the rear speakers all the way up using the stereo?
Sep 9, 2011 at 5:46 PM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
Yea its factory I tried that also but nothing.
Sep 9, 2011 at 6:10 PM
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
OK, next try and check the amplifier it is located behind the right quarter panel trim panel. Check all connections and try to wiggle the wires there with the radio on. Check to see that it is getting power on the green/white wire.
Sep 9, 2011 at 6:21 PM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
Ok I will do that here in a little bit and let you know thanks so much.
Sep 9, 2011 at 6:34 PM
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
ok. I'll be off until Sunday so another technician might help you, if not then I'll help more on Sunday.
Sep 9, 2011 at 6:36 PM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
Sounds good thanks again for your time.
Sep 9, 2011 at 6:41 PM
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
Anything new on this problem?
Sep 14, 2011 at 11:56 AM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
So exactly where is the Amplifier Located? I'm going to have a Buddy look at it this weekend and I will keep you informed thanks again!
Sep 14, 2011 at 6:01 PM
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
On the inside of the car in the rear of the vehicle. It is inside the trim panel located on the right side.
Sep 14, 2011 at 6:16 PM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
Ok thanks, me and my Buddy Saturday will take a look he works on Stereos so this info will be a big help ill keep you informed.
Sep 14, 2011 at 7:48 PM
Avatar
TLOWDON
  • MEMBER
  • 23 POSTS
Looks like the Amp is bad so I'm going to get a used one on EBay and see if that solves the problem ill let you know the Auction ends in 4 days so ill tell you the outcome thanks again!
Sep 17, 2011 at 7:37 PM
Avatar
PROMECHANIC
  • Experienced Mechanic
  • 536 POSTS
Sounds good. I hope that does it for you.
Sep 17, 2011 at 7:49 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.