Clutch replacement

1994 NISSAN HARDBODY
2WD • MANUAL
Avatar
ALASKADOR1
  • MEMBER
  • 1 POST
hi! i'm planning to replace my clutch. if i replace my clutch is there any adjustment on the pressure plate or just put it in just like the original setup? thanks! rene
Dec 24, 2010 at 1:46 PM
Advertisement
Avatar
MHPAUTOS
  • ✓Experienced Mechanic
  • 31,937 POSTS
Just bolt it up as the old one came out, make sure that you have the flywheel machined as if you don't you may have shudder problems, use a clutch aligner and replace the spigot bearing in the end of the crank shaft as well.

mark (mhpautos)
Dec 29, 2010 at 12:50 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.