Clutch replacement

1994 NISSAN HARDBODY
2WD • MANUAL
Avatar
ALASKADOR1
  • MEMBER
  • 1 POST
hi! i'm planning to replace my clutch. if i replace my clutch is there any adjustment on the pressure plate or just put it in just like the original setup? thanks! rene
Dec 24, 2010 at 9:46 PM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
Just bolt it up as the old one came out, make sure that you have the flywheel machined as if you don't you may have shudder problems, use a clutch aligner and replace the spigot bearing in the end of the crank shaft as well.

mark (mhpautos)
Dec 29, 2010 at 8:50 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.