Magna timining chain installation.

1994 MITSUBISHI MAGNA
340,000 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
ZNIKA
  • MEMBER
  • 1 POST
I have a 1994 TS Mitsubishi 2.6 litre, 4 cylinder, Magna. I am trying to replace the timing and balance shaft chains. The instruction manual mentions that I must align "plated links" with marks on each of the gears. On the timing chain, there are supposed to be 2 plated links. The balance shaft is supposed to have 3 plated links. Unfortunately I have only been able to identify one plated link per chain. Can you suggest a better way to align these components properly. Your prompt reply would be appreciated. Thanks Michael.
Feb 22, 2011 at 8:14 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 41,814 POSTS
Our database does not have any information on this engine.

Recheck the links. For both chains, note if any of the links seems to be darker than others. Those should be equivalent to being plated.
Mar 1, 2011 at 7:51 PM
Advertisement