How and where do you check the transmission fluid?
Apr 11, 2013 at 3:47 AM
1994 MITSUBISHI DIAMANTE
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
There is a dipstick at side of transmission for checking the fluid level.
1. Park vehicle on level area. Ensure oil is at normal operating temperature, parking brake is engaged, and engine is at idle. Move gear selector through each position, stopping briefly at each selection.
2. Place gear selector in Neutral, and clean area around dipstick tube. Ensure fluid level is between lower and upper marks, but never over upper mark, in HOT range. Add or drain fluid if necessary.
CAUTION:
If severe darkening of fluid and strong odor are noted, change fluid and filter, and adjust bands.
1. Park vehicle on level area. Ensure oil is at normal operating temperature, parking brake is engaged, and engine is at idle. Move gear selector through each position, stopping briefly at each selection.
2. Place gear selector in Neutral, and clean area around dipstick tube. Ensure fluid level is between lower and upper marks, but never over upper mark, in HOT range. Add or drain fluid if necessary.
CAUTION:
If severe darkening of fluid and strong odor are noted, change fluid and filter, and adjust bands.
Apr 11, 2013 at 1:06 PM
Advertisement