1994 LEXUS LS 400
115,016 MILES
Avatar
SA WMS
  • MEMBER
  • 1 POST
Crank, no start- replaced egr pipe for rot out and ran great. Parked outside for the weekend now cranks but no start. Check engine light is on 100% of time, key in or out, air bag light is now on as well. Checked fuel pressure- 39psi but needed to jump it on underhood dlc to get pump to come up. Spark is good, crankk sensor is ok, wires as well. No fuel injector pulses. Possible ecm or ignition? Battery is dying constantly, related to ses light on dash. Ruled out cam sensor as spark plugs are firing but I'mat a loss at this point and Lexus has me running in circles.
Dec 5, 2012 at 7:44 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
Cam sensors are for the fuel injectors, while crank sensor is for the ignition sparks.
Pump not running is due to power supply failure and the EGR is not the cause of the initial non starting. If fuel pump is manually turnewd on, does engine start? Did you try starting fluid? The fuel injectors could be not pulsing.
Dec 5, 2012 at 8:40 PM
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
What are the trouble codes present?
Dec 5, 2012 at 8:41 PM