1994 Isuzu Rodeo replacing a lug stud

1994 ISUZU RODEO

98,000 MILES • V6 • 4WD • AUTOMATIC

MS871

MEMBER
1 POST
FOLLOW

I am replacing a lug stud on this vehicle. I have all the bolts holding the wheel hub out. i got the wheel hub moved about 1.5 centimeters out , it will not move any further. is there a step i missed to remove it.

Jul 9, 2015 at 2:23 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

JACOBANDNICKOLAS

AUTOMOTIVE REPAIR CONTRIBUTOR
110,190 POSTS

I don't know if you have automatic hubs or manual hubs. I have attached an exploded view of both systems. Take a look at them and let me know if they help.

On the automatic hub, there are six bolts that need removed to take off the hub cap and housing. Once that is off (and you have the caliper off) there is a lock washer and then the hub nut. Once that is off, the rotor/hub assembly should come off. NOTE: Look at number 4. It is a snap ring and shims. They MUST be removed.

Also, make sure the vehicle is in 2wd.

Let me know if this helps.

Joe

Images (Click to enlarge)

Jul 9, 2015 at 8:37 PM