Clutch pedal goes to the floor even after replacing the master and slave twice

1994 ISUZU TRUCK
200,000 MILES • 3.1L • 6 CYL • 4WD • MANUAL
Avatar
BRIAN KELLEY
  • MEMBER
  • 1 POST
There is a a cast metal box the hydraulic lines go to and from between the master and the slave but I have yet to find the name of it.

What is it and could it be my problem?
Jan 13, 2021 at 5:06 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KASEKENNY
  • CAR REPAIR CONTRIBUTOR
  • 18,907 POSTS
Can you get a picture of this part and I am sure we will be able to identify it?

As for the clutch not returning you most likely have an issue with release bearing. When you put the slave in it, did you replace this as well? Here are some guides that will help with this:

https://www.2carpros.com/articles/pilot-bearing-replacement

https://www.2carpros.com/articles/throw-out-bearing-replacement

Also, we need to make sure this is being bleed completely so I attached the info on how to do this just to make sure we are not missing something.

Let's start with this and go from there. Thanks
Images (Click to enlarge)
Attached Media
Attached Media
Jan 13, 2021 at 6:24 PM
Advertisement