1994 GMC C2500
194,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
how do i replace a blower control switch
Oct 20, 2012 at 1:51 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
you have to replace the whole control unit or at least pull it out and then replace the switch but not sure that is possible. it may be just the resistor for lower speeds if that is what is wrong. there is a bezel that goes around this controlheld with screws and or clips it come off and pull the controller to get to blower switch.
Oct 20, 2012 at 4:12 PM
Advertisement