1994 ford tempo go with 2.3l Hsc 4 cylinder
Feb 18, 2012 at 4:38 AM
Where is the tachometer wire located on my engine that I can splice into to put in a custom gauge?
1994 FORD TEMPO
TEMPOUSER
- MEMBER
- 2 POSTS
Advertisement
BILLYMAC
- ✓ASE Certified Mechanic
- 2,204 POSTS
the tach signal comes off the cranksensor and then to the module you can't tap into these wires if you are going to tap into it you will need a reluctor for the coil wire or tap into the rear of the tach on the dash.complicated
Feb 18, 2012 at 4:44 AM
My tempo did not come with tach in the first place, would there be somewhere in the panel itself for it?
Feb 18, 2012 at 5:01 AM
BILLYMAC
- ✓ASE Certified Mechanic
- 2,204 POSTS
just run your tach wire to the coil to whereever it operates your new tach.
Feb 18, 2012 at 3:22 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.