There is no power going to the clutch and the fuses are good.
May 6, 2012 at 9:27 PM
I have a 1994 Ford Ranger V6 3.0L and the AC clutch will not engage.
1994 FORD RANGER
CT731
- MEMBER
- 1 POST
Advertisement
PROMECHANIC
- ✓ASE Certified Mechanic
- 536 POSTS
You most likely have lost pressure in your AC system. Probably the low pressure switch is sensing that there isn't enough freon in the system s it won't turn the ac clutch on.
It could be that the switch is bad too.
These are the most likely causes.
It could be that the switch is bad too.
These are the most likely causes.
May 6, 2012 at 9:37 PM
DJCL
- ✓ASE Certified Mechanic
- 767 POSTS
You could try jumping the low pressure switch on the accumulator to test the electrical part of the circuit. But don't run it to long if its low on pressure its low on oil to. If it runs when jumped have the refrigerantlevel checked
May 6, 2012 at 9:50 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.