I have a 1994 Ford Explorer 4.0 v6 what is the easiest way to remove evaporator coil
Jun 12, 2011 at 10:38 PM
ford explorer
1994 FORD EXPLORER
WALLY1953
- MEMBER
- 2 POSTS
Advertisement
plzz answer
Jun 12, 2011 at 10:39 PM
CJ MEDEVAC
- ✓ASE Certified Mechanic
- 11,004 POSTS
No EZ answer--a Repair Manual would have the Step X Steps and pics and diagrams
Or maybe this will help, it's sorta "Monkey See Monkey Do!"
Let me know if you find something that helps
Good Luck!
The Medic
Or maybe this will help, it's sorta "Monkey See Monkey Do!"
Let me know if you find something that helps
Good Luck!
The Medic
Jun 13, 2011 at 12:12 AM
RASMATAZ
- ✓ASE Certified Mechanic
- 75,992 POSTS
Get a repair manual
EVAPORATOR CORE
NOTE:All major components of evaporator case assembly can be serviced without removing evaporator case from vehicle.
Removal
Disconnect negative battery cable. Discharge A/C system using approved refrigerant recovery/recycling equipment. Disconnect electrical connector from pressure switch on side of accumulator. Remove pressure switch from accumulator. Disconnect suction hose from accumulator. Disconnect refrigerant hose from evaporator. See Fig. 4 . Cap openings.
Remove screws holding evaporator case service cover and vacuum reservoir to evaporator case assembly. Remove evaporator core and suction accumulator-drier assembly from vehicle.
NOTE:Hand-tighten plastic-base clutch cycling pressure switch. Tighten metal-base switch to 60-120 INCH lbs. (7-14 N.m).
Installation
To install, reverse removal procedure. Use new "O" rings lubricated with clean refrigerant oil. Evacuate, recharge, and leak test system.
EVAPORATOR CORE
NOTE:All major components of evaporator case assembly can be serviced without removing evaporator case from vehicle.
Removal
Disconnect negative battery cable. Discharge A/C system using approved refrigerant recovery/recycling equipment. Disconnect electrical connector from pressure switch on side of accumulator. Remove pressure switch from accumulator. Disconnect suction hose from accumulator. Disconnect refrigerant hose from evaporator. See Fig. 4 . Cap openings.
Remove screws holding evaporator case service cover and vacuum reservoir to evaporator case assembly. Remove evaporator core and suction accumulator-drier assembly from vehicle.
NOTE:Hand-tighten plastic-base clutch cycling pressure switch. Tighten metal-base switch to 60-120 INCH lbs. (7-14 N.m).
Installation
To install, reverse removal procedure. Use new "O" rings lubricated with clean refrigerant oil. Evacuate, recharge, and leak test system.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Click here to log in and view diagram.
Jun 13, 2011 at 3:11 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.