electrical problem

1994 FORD AEROSTAR
120,000 MILES • 2WD • AUTOMATIC
Avatar
MBEAVY
  • MEMBER
  • 12 POSTS
i have a 1994 ford aerostar 3.0 engine. my turn signals won't work, and every new fuse i install pops immediately. how do i find the short?
Jul 24, 2011 at 1:53 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
Remove all indicator globes including any side guard indicators, turn on left and start replacing globes, do same with right side, hopefully when you hit the globe with the faulty wire the fuse will pop.
Jul 24, 2011 at 5:49 AM
Advertisement
Avatar
MBEAVY
  • MEMBER
  • 12 POSTS
Thanks for responding to my question. I tried to do what you suggested, but as soon as i put in a fuse, even with all the bulbs out, it would blow. this is a 15 amp fuse spot, and I did try a 30 amp once and it stayed on for 10 seconds, then blew, but not long enough for me to re-insert any bulbs. Any idea what this is telling me? Any advice would be welcome. Thank you
Jul 25, 2011 at 3:02 AM
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
un plug the indicator switch and try again.
Jul 25, 2011 at 4:52 AM
Avatar
MBEAVY
  • MEMBER
  • 12 POSTS
Do you mean the flasher?
Jul 26, 2011 at 12:25 AM
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
yes, same thing
Jul 26, 2011 at 2:47 AM