how to install abs control module 1997 ford ranger?
Nov 19, 2012 at 9:19 AM
1994 FORD FIVE HUNDRED
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
REMOVAL
Disconnect the battery cables and remove the battery.
Wire Harness Connector And Anti-Lock Brake Control Module
Locate the ABS control module electrical connector in front and to the right of the battery tray. Disconnect the connector.
Remove the ABS control module-to-radiator support screw.
Slide the ABS control module to release the retaining tab and remove the module from the vehicle.
INSTALLATION
To install, reverse the removal procedure, noting the following:
Tighten the module-to-radiator support screw to6-8 Nm (53-71 inch lbs.) .
Disconnect the battery cables and remove the battery.
Wire Harness Connector And Anti-Lock Brake Control Module
Locate the ABS control module electrical connector in front and to the right of the battery tray. Disconnect the connector.
Remove the ABS control module-to-radiator support screw.
Slide the ABS control module to release the retaining tab and remove the module from the vehicle.
INSTALLATION
To install, reverse the removal procedure, noting the following:
Tighten the module-to-radiator support screw to6-8 Nm (53-71 inch lbs.) .
Nov 19, 2012 at 1:18 PM
Advertisement