SPONSORED LINKS

Mass air flow sensor 94 Buick park ave

Tiny
I525954
  • MEMBER
  • 1994 BUICK PARK AVENUE
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 180,000 MILES
How do you replace mass air flow sensor on 94 Buick park ave
Saturday, March 5th, 2011 AT 7:25 PM

4 Replies

Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
The MAF is located in the throttle body, 2 screws hold it in

See the diagram below for location
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Saturday, March 5th, 2011 AT 7:51 PM
Tiny
MYMESH
  • MEMBER
  • 2 POSTS
  • 1994 BUICK PARK AVENUE
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 20,000 MILES
My 1994 Buick Park Avenue is about to drive me nuts! As long as I am driving on the open highway, it keeps going. It stutters from time to time, but I can live with that. But the minute I hit start and stop traffic, after a few redlights, it will start sputtering, then kill out. We've replaced the fuel pump, cleaned the injectors, and replace the wiring harness that goes to the mass air flow sensor. We are about to replace the mass air flow sensor. But it costs $130+ and I want to make sure that it can cause the problems I have described, or if we need to look elsewhere. Please help! I am desperate. I'm almost out of money to keep putting in this car.
Was this
answer
helpful?
Yes
No
Saturday, November 3rd, 2018 AT 8:07 AM (Merged)
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check and test the following below:

Oygen Sensor
Catalytic Converter
Dirty fuel injectors (cleaning the injectors often fixes this).
Bad MAP (manifold absolute pressure) sensor
Bad TPS (throttle position) sensor
Bad or dirty MAF (mass airflow) sensor
Low fuel pressure (leaky fuel pressure regulator or weak fuel pump)
Vacuum leaks (intake manifold, vacuum hoses, throttle body, EGR valve)
Bad gasoline (fuel contaminated with water or too much alcohol)

Sometimes, what feels like a hesitation is actually ignition misfire rather than lean misfire. The causes of ignition misfire may include:

Dirty or worn spark plugs
Bad plug wires
Weak ignition coil
Wet plug wires
Cap and Rotor

Note:If it doesn't apply, disregard.
Was this
answer
helpful?
Yes
No
Saturday, November 3rd, 2018 AT 8:07 AM (Merged)
Tiny
MYMESH
  • MEMBER
  • 2 POSTS
Thank you for such a rapid response. Will try what you have suggested. Thanks again!
Was this
answer
helpful?
Yes
No
Saturday, November 3rd, 2018 AT 8:07 AM (Merged)

Please login or register to post a reply.

Related Mass Air Flow Sensor Replace/Remove Content

Mass Air Flow Sensor Replacement
GUIDE
Mass Air Flow Sensor Replacement
After starting the engine post sensor replacement, the sensor instantly calibrates itself so there is no learn time required. This sensor is subject to debris and ...
VIEW MORE

Sponsored links