1994 Acura Legend Hello 94 Sedan Common Starting Issues Relay Replaced Bad I

1994 ACURA LEGEND
177,000 MILES
Avatar
GARY
  • MEMBER
  • 2 POSTS
Hello I have a 1994 legend sedan. I know the common not starting issues with the relay. I have replaced it (was bad) install a new battery and I can get it to run if I spray starting fluid into it. I found a wire diagram you have posted for someone
Feb 23, 2012 at 7:01 PM
Advertisement
Avatar
RASMATAZ
  • Experienced Mechanic
  • 75,992 POSTS
You need to be more specific is to your problem, give more details.
Mar 6, 2017 at 7:47 AM
Avatar
GARY
  • MEMBER
  • 2 POSTS
Okay, well my car is not getting fuel. After some looking into this problem I see that the relay is very common to go bad. I removed mine and is was bad. I have replaced with a new one and a new battery. The car still would not start so I check for fuel at the filter and there is no fuel. The will start with starting fluid but will not stay running if not sprayed. I have seen a diagram that was used on here and found that there is a black/yellow wire from the relay to the fuel pump. At the relay there r two black/yellow wires one is bigger than the other and the bigger one of the two has twelve volts with the key on. So I looked for the.same black/yellow wire. in the trunk going down to the fuel pump. and tested it for twelve volts, I got nothing. I do not hear the pump coming on. Am I testing the right wire or am I missing something? Thanks
Mar 6, 2017 at 7:47 AM
Avatar
RASMATAZ
  • Experienced Mechanic
  • 75,992 POSTS
Check the ground black wire at G110 and fuse number twenty two. see below.



Mar 6, 2017 at 7:47 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.