VW Eurovan heater fan replacement

BLOWER MOTOR & RESISTOR
Removal & Installation (Front)
Open glove box. Remove glove box light, and disconnect wiring harness. Remove 7 screws and glove box. Disconnect wiring harness from blower motor resistor. Remove blower motor resistor (if necessary).
Disengage locking tab, and rotate blower motor clockwise. To remove blower motor, pull blower motor toward center of instrument panel. To install blower motor or resistor, reverse removal procedure. See Fig. 4.
Removal & Installation (Rear)
Raise and support vehicle. Locate rear heater housing underneath vehicle. Disconnect wiring harness from rear blower motor. Remove rear blower motor. To install rear blower motor, reverse removal procedure.
NOTE:Rear blower motor resistor removal and installation procedure is not available from manufacturer. Rear blower motor resistor is located on left side of engine compartment.

Fig. 4: Exploded View Of Front Heater Assembly