1993 Saturn SL2 Vacuum line connection

1993 SATURN SL2

140,000 MILES • 4 CYL • FWD • MANUAL

FORDFALCON54

MEMBER
1 POST

Tried to clean my throttle out and as I was taking it out I accidentally cracked the vacuum line. Anyway I got two out of the three put back together the one I'm stuck on is the solenoid vacuum connection. I don't know where the solenoid is located in my car. I have the basic diagram but it doesn't help me very much so if I could get a better diagram that would be amazing and greatly appreciated and from what I've seen so far I'm suppose to connect it to the top nipple not the bottom one on the solenoid correct?

Jan 30, 2014 at 6:01 PM

SATURNTECH9

✓ASE Certified Mechanic
30,869 POSTS

Its the top and its under the intake manifold if your looking for the canister purge solenoid.

Jan 30, 2014 at 6:15 PM

MLDANIELS2000

✓ASE Certified Mechanic
227 POSTS

I can get a vacuum diagram but need an engine size.

Jan 30, 2014 at 6:54 PM

SATURNTECH9

✓ASE Certified Mechanic
30,869 POSTS

Really dont need a vacuum diagram for that car there isnt many lines and there straight runs.Goes from the throttle body to the canister purge solenoid under the intake manifold. The other line goes from the throttle body to the egr solenoid mounted to the valve cover.Then the from the intake vacuum nipple goes to the pcv in the valve cover.

Jan 30, 2014 at 7:39 PM

SATURNTECH9

✓ASE Certified Mechanic
30,869 POSTS

Also those cars only have one engine size 1.9L that one is a dual overhead cam.They also made a 1.9L single cam engine same vacuum set up.

Jan 30, 2014 at 7:42 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.