1993 Pontiac Transport 3800 V6 Injector Trouble

1993 PONTIAC TRANSPORT
204,000 MILES • 6 CYL • FWD • AUTOMATIC
Avatar
DEBE
  • MEMBER
  • 1 POST
I have a 1993 Pontiac Transport 3.8 6-Cylinder. I replaced the fuel filter which I am guessing I put bad gas in it because it was all dirty when I took the lines off and replaced it. Put new one on and it ran good. Two days later started cutting out and died. Ended up having to pour gas on the air filter each time it died until I could get home. Replaced the fuel pump, spark plugs, took off injectors and cleaned, and now it will turn over somewhat but then dies. Checked the injectors with a test light & multimeter. Reads 12V but not reading a pulse. Any suggestions? Running out of ideas.
Jul 24, 2011 at 11:37 AM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,992 POSTS
Are you getting an ignition spark from the plugs? -no pulses from the injectors could mean the ground driver circuit of the injector built-in into the computer or an input signal from a sensor is missing therefore the computer will not synchronize the injectors
Oct 12, 2011 at 12:42 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.