SWAP

1993 PONTIAC GRAND AM
6 CYL • 2WD • AUTOMATIC
Avatar
BENSYLVARA
  • MEMBER
  • 2 POSTS
Iv got a 1993 pon gand am GT... Has the 3.3 L in it 4 door all black nice little car.... But the rod bearings went, every single on of them and instead of A REBUILD. i wont to drop something ells Bigger in it. like an 8 but i cant find any were on the internet that can tell me if an 8 would fit and what one. Also if the 3.3 transmion would line up or work. Any advice iv never done this before.....
Jun 12, 2011 at 6:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
WRENCHTECH
  • CAR REPAIR CONTRIBUTOR
  • 20,761 POSTS
No, you can't put anything but the exact same engine that you took out. The operating system will only operate that engine.
Jun 12, 2011 at 9:11 PM
Advertisement
Avatar
BENSYLVARA
  • MEMBER
  • 2 POSTS
Ok if i swich the computer and wiring harness. what motor$ tranny would be able to fit with out chan
ging the engine mounts?
Jun 12, 2011 at 11:20 PM