where do you put a mass air flow sensor on a 93 oldsmobile delta 88?
Mar 24, 2011 at 5:13 PM
mass air flow sensor
1993 OLDSMOBILE DELTA 88
ANNA793
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
REMOVAL:
1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly and fresh air duct.
3. Remove the MAF sensor electrical connector.
4. Remove the 4 MAF attaching screws.
5. Remove MAF sensor.
NOTE: Do not attempt to remove the MAF sensor gasket. It is not removable, and is not serviced separately.
INSTALLATION:
1. Install the MAF sensor with attaching screws.
2. Connect the MAF sensor electrical connector.
3. Install the air cleaner assembly and fresh air duct.
4. Connect the negative battery terminal.
1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly and fresh air duct.
3. Remove the MAF sensor electrical connector.
4. Remove the 4 MAF attaching screws.
5. Remove MAF sensor.
NOTE: Do not attempt to remove the MAF sensor gasket. It is not removable, and is not serviced separately.
INSTALLATION:
1. Install the MAF sensor with attaching screws.
2. Connect the MAF sensor electrical connector.
3. Install the air cleaner assembly and fresh air duct.
4. Connect the negative battery terminal.
Image (Click to enlarge)
Mar 24, 2011 at 5:35 PM
Advertisement