Possibly a new fuel filter if only taking off slowly but if actually missing then tune up. First I would have it scanned for codes if no codes then tune up and fuel filter
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Sunday, February 6th, 2011 AT 4:31 PM
COLLINSANTONIO
MEMBER
16 POSTS
Already changed fuel filter
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 4:33 PM
BILLYMAC
MECHANIC
2,204 POSTS
Is the engine misfireing running rough?
Was this
answer
helpful?
Yes
No
+1
Sunday, February 6th, 2011 AT 4:35 PM
COLLINSANTONIO
MEMBER
16 POSTS
New fuel pump too it was driving fine until one day I cut it off then went back out to go and it started missing.
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 4:36 PM
COLLINSANTONIO
MEMBER
16 POSTS
Yes sir
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 4:37 PM
BILLYMAC
MECHANIC
2,204 POSTS
Do you have any codes check eng light? Normally this is either a fuel prob or a cat convertor there will be codes stored for the cat prob.
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 4:38 PM
COLLINSANTONIO
MEMBER
16 POSTS
Yes sir check engine light is on and off at times. It has a small oil leak coming from up top running down on the oil filter.
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 4:52 PM
BILLYMAC
MECHANIC
2,204 POSTS
You can have it scanned for free at your local advance auto orielys or auto zone near you. This will more then likely tell you where the prob is but sounds like a restricted convertor to me good luck
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 4:55 PM
COLLINSANTONIO
MEMBER
16 POSTS
Could it be just one cat since it have three of them or anyway to bypass?
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 4:58 PM
BILLYMAC
MECHANIC
2,204 POSTS
Yes it could be only one the scan will tell you which one is causing the prob.
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 5:03 PM
COLLINSANTONIO
MEMBER
16 POSTS
Could it be just one cat conv?
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 5:30 PM
COLLINSANTONIO
MEMBER
16 POSTS
Estimated cost on that
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 5:34 PM
COLLINSANTONIO
MEMBER
16 POSTS
My car is a 93 so I need a diagnostic from under the hood
Was this
answer
helpful?
Yes
No
Sunday, February 6th, 2011 AT 5:36 PM
BILLYMAC
MECHANIC
2,204 POSTS
They have adaptors for pre obd vehicles like yours. But if you want to confirm quicker just loosen exhaust at manafold and test drive. If this is not an option go to exhaust shop they can do backpressure test on your convertors and idenify the failing one.
Cost prob under 25.00