I put gas in my 93 ford thunderbird and now it won't run. I replaced the fuel filter and added heat and injector cleaner. What else can I do?
Jun 23, 2011 at 1:55 AM
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
JDL
AUTOMOTIVE REPAIR CONTRIBUTOR
16,098 POSTS
If it cranks good but won't start, have a helper crank it, while you check for spark at the plugs. If you have spark everywhere, use a gage and check fuel pressure.
You need to make sure the battery has a full charge or you can't test anything.
Jun 23, 2011 at 2:32 AM
Advertisement
SLMB
MEMBER
2 POSTS
It now will run for about a minute then chokes out.but it will only start after it sits for 20 minutes.
Jun 23, 2011 at 3:51 AM
RASMATAZ
AUTOMOTIVE REPAIR CONTRIBUTOR
75,992 POSTS
Next time it refuses to start don't wait for it to make up its mind-do below immediately to determine if its fuel or spark problem as suggested earlier