1993 Ford Ranger 93 A4ld Automatic Trans Every Time Put Gear Stalls Out Changed

1993 FORD RANGER
185,000 MILES
Avatar
DBAYARD93RANGER
  • MEMBER
  • 1 POST
I have a 93 ranger with the a4ld automatic trans and every time I put it in gear it stalls out so I changed the torque converter and both solenoids and for about 30 mins after that it would go into gear an start to go for about 5 feet an then it would act like it just went into nutrual an after about a half hour after that it would stall out again when I put it in gear but if I jack up the rear end so the tires are off the ground everything works fine
Jan 31, 2013 at 5:00 AM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
scan for codes and check fule pressure first it may be an engine problem
Jan 31, 2013 at 2:42 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.