DTC 332 EGR VAULVE

1993 FORD EXPLORER
170,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
MTCAIME
  • MEMBER
  • 13 POSTS
I HAVE A 93 FORD EXPLORER 4X4 V6 4.O CHECK ENGINE LIGHT ON PULL CODES AND FOUND DTC 332
CHECKED AND CLEANED EGR VAULVE AND PERFORMNED VAC TEST AND PAST, WHAT NOW???
Mar 16, 2011 at 8:28 AM
Advertisement
Avatar
MHPAUTOS
  • ✓ASE Certified Mechanic
  • 31,937 POSTS
  • ASE Certified Mechanic
More than likely a faulty valve.
Mar 16, 2011 at 9:48 AM
Avatar
WRENCHTECH
  • ✓ASE Certified Mechanic
  • 20,761 POSTS
  • ASE Certified Mechanic
That is an insufficient flow code. there are 2 common causes of that. The first is the passage that goes through the throttle body getting plugged up with carbon. You would usually have to remove the throttle body and clean the passage with a coathanger.
Another common cause of that on Fords is a bad DPFE sensor, also called an EGR pressure transducer.
Mar 16, 2011 at 12:19 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.