after performing a tune up my tach (RPM) gauge was inoperable, which sensor, connector or cable delivers info to indicate the engines rpm?
Aug 29, 2011 at 9:43 PM
some time i can shake all the wiring harness and connectors and the RPM guage works again
1993 FORD EXPLORER
ROYAQUA
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
NORMALLY YOUR TACHOMETER'S SIGNAL COMES FROM THE "NEGATIVE SIDE OF THE COIL"
NOT ONLY RECONNECT CONNECTORS, BUT WITH THEM DISCONNECTED, INSURE THE CONTACTS HAVE NOT "BEEN SHOVED REARWARD" IN THEIR CONNECTOR, AND DO NOT CONNECT PROPERLY...DIELECTRIC GREASE NEVER HURTS, ON CONNECTIONS EITHER!
IF YOU STILL CANNOT FIND THE PROBLEM, LET ME KNOW, I'LL TRY TO GET YOU A WIRE DIAGRAM....TO DO SO, I NEED MORE SPECIFIC INFO ON YOUR RIG AND ENGINE SIZE
THE MEDIC
NOT ONLY RECONNECT CONNECTORS, BUT WITH THEM DISCONNECTED, INSURE THE CONTACTS HAVE NOT "BEEN SHOVED REARWARD" IN THEIR CONNECTOR, AND DO NOT CONNECT PROPERLY...DIELECTRIC GREASE NEVER HURTS, ON CONNECTIONS EITHER!
IF YOU STILL CANNOT FIND THE PROBLEM, LET ME KNOW, I'LL TRY TO GET YOU A WIRE DIAGRAM....TO DO SO, I NEED MORE SPECIFIC INFO ON YOUR RIG AND ENGINE SIZE
THE MEDIC
Aug 30, 2011 at 12:07 AM
Advertisement