tension pulley

1993 DODGE SPIRIT
999,999 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
CLEATUS
  • MEMBER
  • 1 POST
belt keeps slipping off of tension pulley
Nov 30, 2010 at 8:52 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MHPAUTOS
  • CAR REPAIR CONTRIBUTOR
  • 31,937 POSTS
On of the pulley will be out of alignment, normally due to a bad bearing, also check that the front engine pulley is ok, there is no end movement and if it is a rubber type harmonic balancer that the outer section has not started to detached from the hub.

mark (mhpautos)
Dec 1, 2010 at 1:06 PM
Advertisement