SPONSORED LINKS

1993 Dodge Shadow Hamtramck

Tiny
JAY103
  • MEMBER
  • 1993 DODGE SHADOW
  • 150,023 MILES
Hello,
Just had a trans put in my 93dodge, shadow 2.2engine in reverse it shakes and virbrate hard I replaced the two motor mounts and it stop it a little but the problem is still there what can this be (if I need my lower balls joints replaced can that be it? Including struts which I have will this stop it)
SPONSORED LINKS
Monday, September 16th, 2013 AT 6:37 PM

3 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
The struts or ball joints won't cause a vibration. Is the engine running rough or does it feel like the transmission is slipping?
Was this
answer
helpful?
Yes
No
Monday, September 16th, 2013 AT 6:38 PM
Tiny
JAY103
  • MEMBER
  • 5 POSTS
Engine was at high idle adjusted the screw and now its fine doesn't feel like the Trans slipping it drives and change gears fine just in reverse it shakes like the car is bout to fall aparr
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, September 17th, 2013 AT 8:15 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
If it only happens in reverse, it sounds like it is related to the transmission. Is the fluid clean and full? And does it vibrate at all in drive?
Was this
answer
helpful?
Yes
No
Tuesday, September 17th, 2013 AT 5:57 PM

Please login or register to post a reply.

Related Mount Replace/Remove Content

Engine Mount Replacement
GUIDE
Engine Mount Replacement
Engine mounts are made of durable rubber which cushions the engine vibration from the vehicle frame. These mounts hold the engine in the car and are bolted to the engine...

Sponsored links