dakota stalling

130,000 MILES • 6 CYL • 4WD • MANUAL
Avatar
BJMINC1
  • MEMBER
  • 2 POSTS
i have a 1993 doodge dakota truck with a 3.9L engine
was driving down the highway one day and engine just cut out. i have checked the fuel pump pressure 30 psi, ohmed out the coil primary and secondary both are right where they should be 1 ohm and 13,800 ohms. when i checked the fault code it was a 36 indicating (air switching solenoid circuit) my truck has a MPI ignition system didn't think that had an assc, i took the codes from a Haynes manual, need help !!!if it has some type of air sensor where is it ?
Jun 19, 2011 at 9:48 AM
Advertisement
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
Will the vehicle start and run? How long since a tune-up? I looked at 2 different databases, no code 36 listed for your vehicle. My fuel pressure spec showed 39 psi for this vehicle. With fuel injection, there has to be an rpm signal or you may loose fuel and spark both? Let us know.
Jun 19, 2011 at 10:17 AM
Avatar
BJMINC1
  • MEMBER
  • 2 POSTS
vehicle will not start,haynes manual says 31 psi, tune up was about 30,000 miles ago the code is definately 36 checked it 3 times at least. can't figure it out
Jun 19, 2011 at 11:03 AM
Avatar
JDL
  • ✓Experienced Mechanic
  • 16,098 POSTS
If it cranks good, but won't start, have a helper crank it, while you check for spark at the plugs. You can take a spark plug wire loose, use a known good spark plug or spark tester in the boot, ground/touch metal part of tester to metal part of engine, engine cranking, watch for spark. If you have spark everywhere, check for injector pulse, use a noid lite.
Jun 19, 2011 at 11:43 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle

Advertisement