Instrument Panel

1993 CHRYSLER CONCORDE
200,000 MILES
Avatar
PAMCONNOLLY48
  • MEMBER
  • 1 POST
1. Installed new ignition switch and lock cylinder. 2 days later instrument panel gages stopped working and a/c is stuck on heat. Had car totally checked out, bcm, ecm, pcm, mmmmmmmm, all circuits, groundings, wirings, fuses, relays, etc., pulled old instrument cluster, and tested the plugs in engine panel and they are ok asa well, grounded and power, so determined it was instrument panel itself. Ordered new/used one, installed it and nothing on that one either. Did I get bad insrument cluster?
Apr 21, 2012 at 10:05 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓ASE Certified Mechanic
  • 52,796 POSTS
  • ASE Certified Mechanic
possibly, but i would verify that the fuses are good. test them with a volt meter or test light to verify power.

i would start there

Roy
Apr 21, 2012 at 10:07 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.