broken interior door handles

1993 CHRYSLER CONCORDE
6 CYL
Avatar
DALIONSOULED
  • MEMBER
  • 3 POSTS
The door trim piece that holds the interior door handle on my 1993 concorde is broken. I haven't been able to find a replacement so I'm wondering if there's a compatible door panel from another car.
Nov 25, 2010 at 10:37 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,240 POSTS
None that will be an exact match. Have you tried looking at online salvage yards? Also, the interior handle is screwed into place. Is that what broke?
Nov 25, 2010 at 10:42 PM
Avatar
DALIONSOULED
  • MEMBER
  • 3 POSTS
There's the plastic woodgrain insert that holds the switch for the power locks, a vent for the A/C and heat and the handle. The 2 holes that hold the rod and allows the handle to pivot in place when you open the door are broken. As a result when I go to open the door I end up pulling the handle free of everything before the latch is triggered.
Nov 26, 2010 at 4:58 PM
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,240 POSTS
It sounds like the handle itself is broken. It is held in by a screw. Then behind it is the linkage. There is one clip that holds the linkage in place. It turns and clips to the linkage rod. Turn it and the clip will release and come off the handle.
Nov 29, 2010 at 3:35 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.