do you have to take the trans. out to replace the slave cylinder on a 5 speed standard
Oct 24, 2012 at 11:26 AM
1993 Chevrolet Truck You Take Trans Out Replace Slave Cylinder On 5 Speed
1993 CHEVROLET TRUCK
ANONYMOUS
- MEMBER
- 1 POST
Advertisement
ASEMASTER6371
- ✓ASE Certified Mechanic
- 52,796 POSTS
When servicing the clutch actuator with hydraulic line intact, disconnect the clutch master cylinder pushrod from the clutch pedal in order to prevent damage to the actuator should the pedal be depressed.
Raise and support vehicle, then remove actuator cylinder to clutch housing nuts and actuator assembly.
Use hydraulic clutch line separator tool No. J-36221 or equivalent to disconnect actuator cylinder hydraulic line coupling, then remove line from clips if necessary.
Reverse procedure to install, noting the following.
Raise and support vehicle, then remove actuator cylinder to clutch housing nuts and actuator assembly.
Use hydraulic clutch line separator tool No. J-36221 or equivalent to disconnect actuator cylinder hydraulic line coupling, then remove line from clips if necessary.
Reverse procedure to install, noting the following.
Oct 24, 2012 at 11:29 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.