Hello, Did you get your vehicle fixed?
If not did the over heating start before or after the replacement of Rad, Therm and WP. If so you may have air pockets in the system that need to be worked out. This will cause the quick over heat. To work out I usually leave the cap loose and run till hot then shut down for about 5 - 10 min. Top off with water and start vehicle run till hot again rev engine to about 2000 for about 2 min or till temp gauge gets about a 1/4 for red zone. If don't have gauge start vehicle rev at about 2k for 2 min then let idle. In most of the cases I have had this problem you can tell when air pocket has cleared when A/C Starts working normally as long as a/c worked normally before and you have a/c.
Also did you double check to make sure Timing was currect. Timing being off can cause same problem and the lack of power
SPONSORED LINKS
Sunday, July 14th, 2013 AT 12:33 PM