rear hub and bearing assembly

1992 SATURN SL1
4 CYL • 2WD • AUTOMATIC
Avatar
BUBBADICKENS
  • MEMBER
  • 13 POSTS
how do i remove my rear hub and bearing assembly on my 1992 Saturn SL1. I took out the 4 bolts behind the flange but it still doesnt want to budge?
Nov 19, 2010 at 10:33 PM
Advertisement
Avatar
BLUELIGHTNIN6
  • ✓ASE Certified Mechanic
  • 16,542 POSTS
  • ASE Certified Mechanic
removal steps are below
Nov 19, 2010 at 10:42 PM
Avatar
SATURNTECH9
  • ✓ASE Certified Mechanic
  • 30,869 POSTS
  • ASE Certified Mechanic
If your only removing the hub and bearing like it sound's like your doing there is no need to loosen the knuckle bolt's and mess up your alignment.All you do is remove the four bolt's facing your drum or rotor and if it won't break loose spray some liquid wrench on the mating surface of the hub/bearing to the knuckle and let it soak for a while then use a hammer to break it loose by hitting where the drum or rotor goes on with the drum or rotor off.
Nov 20, 2010 at 5:59 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.