SPONSORED LINKS

Turning signals

Tiny
KURTISG904
  • MEMBER
  • 1992 PONTIAC SUNBIRD
  • 6 CYL
  • 2WD
  • AUTOMATIC
My turning signals do not work, I think its a connection problem, my bulbs are all fine, and my turning switch works, high beams work, and hazards work, what could be the reason my turning signals dont respond and work?
Monday, February 7th, 2011 AT 4:48 AM

3 Replies

Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Check for voltage and ground at turn bulb wiring, dark green wire is voltage for turn signal, black is ground. The key should be on. If no voltage, I'd have to check feed to and from the turn switch.
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, February 7th, 2011 AT 9:49 PM
Tiny
KURTISG904
  • MEMBER
  • 11 POSTS
Where is the dark green and black wire located?
Was this
answer
helpful?
Yes
No
Monday, February 7th, 2011 AT 10:38 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
At the rear turn signals. Are you talking about the rear turn signals. Have you ever replaced a bulb? The socket has wires on it. You may have to look on backside of assembly. The info below is for a sunbird rear lamp.
Image (Click to make bigger)
Thumb
Was this
answer
helpful?
Yes
No
Tuesday, February 8th, 2011 AT 5:32 PM

Please login or register to post a reply.

Related Turn Signal Not Working Content

Turn Signal Problems
GUIDE
Turn Signal Problems
Turn signals are intended to help inform surrounding drivers of the vehicle's intended change in direction. Although there are a few different causes for signal failure...

Sponsored links