where is the cam sensor located on my 1992 Geo Storm I have a 1.6 liter engine

1992 GEO STORM
100,800 MILES
Avatar
ITSYAZ222
  • MEMBER
  • 2 POSTS
I have a 1992 Geo storm it cranks but does not start, i have tested all the sensors except the cam sensor, and I have replaced the main coil, still i get no spark from the coil. the distributor is functioning, all my fuses are good and connections to the battery are fine. where is the cam sensor located it is not mentioned in the Haynes manual or is it called something else?
Mar 18, 2012 at 7:19 PM
Advertisement
Avatar
JDL
  • ✓ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
You don't have one according to my info. Any applicable codes? Did you check primary voltage to the ignition coil? Use a voltage tester.
Mar 18, 2012 at 7:23 PM
Avatar
ITSYAZ222
  • MEMBER
  • 2 POSTS
the codes read no distributor reference pulses to ecm and oxygen sensor circuit(non heated type)
Mar 18, 2012 at 7:44 PM
Avatar
JDL
  • ✓ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
You may have a problem with pick-up coil in distributor?
Mar 19, 2012 at 2:48 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.