i changed everthing that deals with spark still no spark
Nov 21, 2011 at 6:47 PM
getting no spark
1992 FORD BRONCO
DSGB
- MEMBER
- 6 POSTS
Advertisement
Tell me what you have replaced.
Nov 21, 2011 at 8:05 PM
change distriputer, spark maguler, spark plugs, ground battery to the block, coilpack, fuel pump,pick up relay, it will turn over but still no spark.
Nov 23, 2011 at 3:24 PM
Did you replace the ignition module box? It is mounted on the front side of the distributor. Have you checked the crank sensor?
Nov 23, 2011 at 3:32 PM
i dont have a ignition module,it also don't have a crank sensor
Nov 23, 2011 at 5:32 PM
It should have the ignition module on the distributor. I could be losing my mind (lol), but I swear there is one on this year.
Nov 23, 2011 at 6:17 PM
no its on the fire wall
Nov 23, 2011 at 7:35 PM
Got ya.. Have you checked that? The newer ones had a small one on the distributor. I thought this year was the same.
Nov 23, 2011 at 7:49 PM
yes i changed it, i am running out of options, i don't know what it could be
Nov 24, 2011 at 6:28 AM
Just for the heck of it, remove the distributor cap and make sure the rotor turns when cranking the engine.
Nov 24, 2011 at 9:29 AM
yeah did that it does.
Nov 24, 2011 at 12:18 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.