1992 ford aerostar van

1992 FORD AEROSTAR
170,000 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
DIANE BEARD
  • MEMBER
  • 1 POST
Had problems starting, when vanwas switched on, fuel pump ran exceptionally long time, then finally stopped running, then engine would crank as if fuel pressure was sufficient.Recently replaced entire fuel pump assembly. Also checked fuel filters, electrical connections, fuses and relays. Problem now is--fuel pump does not run when ignition is turned to on.Van will not crank. What needs checking now?
Jan 9, 2011 at 2:50 AM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
First, make sure the EEC relay (under the hood in relay block) is good. Switch it with another relay with the same part number to see if the pump runs. If that doesn't help, check the fuel pump relay the say way. If that still doesn't help, you need to check if there is power to the fuel pump relay. If there is, then you need to remove the fuel tank again and check for power at the plug where it attaches to the pump. If there is no power, trace wiring back to relay checking for breaks and power loss. If there is power to the pump and it doesn't run, replace the pump. NOTE: If the pump continues running longer than it should, check the fuel pressure regulator to make sure it is working and check for leaks preventing the system from fully pressurizing.
Jan 13, 2011 at 8:36 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.