TROUBLE CODE 27- injector output circuit not respondin

1992 DODGE DAKOTA
80,000 MILES
Avatar
WOODY863
  • MEMBER
  • 1 POST
Not sure what and/or code means or where to look to fix the engine is a 5.2L just bought the truck not real sure on the history, I do know it has a rebuilt trans., other than that the engine looks clean ( not dealer clean ).
Mar 11, 2012 at 8:26 PM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
DTC 27 Injector #1 control circuit. Injector output driver does not respond properly to the control signal.

Check wiring back to the computer and injector driver circuit
Mar 11, 2012 at 8:41 PM
Avatar
KHLOW2008
  • ✓ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
Clear the code and retest. If problem comes back you wuold need to performs test to diganose the problem.

TEST NS-5A - REPAIRING FAULT "FUEL INJECTOR CONTROL CIRCUIT"

Turn ignition off. Disconnect injector No. 1 connector. Turn ignition on. Using DRB-II, actuate fuel system. Place DRB-II in voltmeter mode. Probe Dark Green/Orange wire in injector connector. If voltage is less than 10 volts, repair open Dark Green/Orange wire. If voltage is 10 volts or more, replace engine controller.
Mar 11, 2012 at 8:43 PM
Avatar
FIXITMR
  • ✓ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
running ok? could be out of spec injector(s) or wiring/plug/ECM issue.
Mar 11, 2012 at 8:50 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.