How do I change out a Master Brake Cylinder on a 1992 Chrysler New Yorker?
Jan 7, 2011 at 9:21 PM
Master Cylinder repair
1992 CHRYSLER NEW YORKER
HAYLEYK247
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Place drain pan under the master cylinder.
Using a suitable wrench, disconnect brake lines from the master cylinder. Plug all lines and fittings.
Remove master cylinder-to-brake booster attaching nuts.
Pull master cylinder outward and away from brake booster.
Reverse procedure to install noting the following:
Prior to installing a new or rebuilt master cylinder, it should be bench bled, refer to Brakes and Traction Control/Brakes/Service and Repair.
Torque master cylinder-to-brake booster attaching nuts to 170-230 lb-in
Torque brake line fittings to 170 lb-in
Using a suitable wrench, disconnect brake lines from the master cylinder. Plug all lines and fittings.
Remove master cylinder-to-brake booster attaching nuts.
Pull master cylinder outward and away from brake booster.
Reverse procedure to install noting the following:
Prior to installing a new or rebuilt master cylinder, it should be bench bled, refer to Brakes and Traction Control/Brakes/Service and Repair.
Torque master cylinder-to-brake booster attaching nuts to 170-230 lb-in
Torque brake line fittings to 170 lb-in
Jan 7, 2011 at 9:32 PM
Advertisement