where do you jumper the circuit on a 1992 Chrysler Lebaron to force the air conditioning compressor to run so I can re-charge the system?
Jun 6, 2011 at 6:22 AM
lebaron air conditioning
1992 CHRYSLER LE BARON
DTHEIM
- MEMBER
- 9 POSTS
Advertisement
This is the incorrect way to do a re gas, you can over charge the system and do serious damage, if you have no refrigerant you have a leak, get the system vacuumed down and do a leak test first. but if you must hot wire it, jump 12V to the compressor clutch wire.
Jun 6, 2011 at 6:31 AM
i tried that wire and clutch did not engage, I was trying to determine whether the compressor was working or not by jumping it.
Jun 6, 2011 at 6:34 AM
Power the magnetic clutch from the battery or jumper the low pressure switch
Jun 6, 2011 at 6:34 AM
If the clutch is being powered-up and not engaging the compressor the magnetic clutch is defective
Jun 6, 2011 at 6:45 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.